AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Number 95 oatey tinning flux12/16/2023 ![]() Because they are soluble in water, you can easily clean any PCB pipes that you use this flux on with regular water. These are stronger compared to other options and can clean off the oxide faster than other options. Wait until the pipes are cooled, disconnect them and start again.Another option that you can use is a water-soluble flux. The pipe may have also been heated too much or too little, which will also cause the solder to bead off. If the solder doesn't run into the joint and forms small beads that roll away from it instead, you might have burnt the flux or may not have cleaned the pipe properly. If there are any areas with insufficient solder, reapply solder as needed. CERCLA Hazardous Substance List (40 CFR 302.4) Ammonium chloride (CAS 1) LISTED Zinc chloride (CAS ) LISTED Superfund Amendments and Reauthorization Act of 1986 (SARA) Immediate Hazard - Yes Hazard categories Delayed Hazard - No Fire Hazard - No Pressure Hazard - No Reactivity Hazard - No SARA 302 Extremely hazardous substance Not listed.Ĭountry(s) or region Japan Inventory name Inventory of Existing and New Chemical Substances (ENCS) On inventory (yes/no)* No Korea Existing Chemicals List (ECL) Yes New Zealand New Zealand Inventory Yes Philippines Philippine Inventory of Chemicals and Chemical Substances (PICCS) Yes United States & Puerto Rico Toxic Substances Control Act (TSCA) Inventory Yes *A "Yes" indicates this product complies with the inventory requirements administered by the governing country(s).Inspect the tinned tip: After applying solder, inspect the tinned tip to ensure that the solder is evenly distributed and covers the entire surface. OSHA Specifically Regulated Substances (.1001-1050) Not listed. This product is not expected to cause reproductive or developmental effects. Overall Evaluation of Carcinogenicity Petrolatum (CAS ) 3 Not classifiable as to carcinogenicity to humans. Germ cell mutagenicity No data available to indicate product or any components present at greater than 0.1% are mutagenic or genotoxic. Explosive limit - upper (%) Not available. ![]() Explosive limit - lower (%) Not available. Flammability limit - lower (%) Flammability limit - upper (%) Not available. Upper/lower flammability or explosive limits Not available. Initial boiling point and boiling range 638.6 ☏ (337 ☌) Flash point 539.6 ☏ (282.0 ☌) Evaporation rate Not available. Melting point/freezing point Not available. Components Type Value Form Ammonium chloride (CAS 1) STEL 20 mg/m3 Fume. OSHA Table Z-1 Limits for Air Contaminants (.1000) Components Type Value Form Petrolatum (CAS ) Tin (CAS ) Zinc chloride (CAS ) PEL 5 mg/m3 Mist. ![]() ![]() Exposure controls/personal protection Occupational exposure limits US. Call a physician if symptoms develop or persist.Ĩ. First-aid measures Inhalation Skin contact Eye contact Ingestion Most important symptoms/effects, acute and delayed Indication of immediate medical attention and special treatment needed General information If breathing is difficult, remove to fresh air and keep at rest in a position comfortable for breathing. ![]() Zinc chloride 10-31-5 4-8 Ammonium chloride 1 1-5 Bismuth 0-1 Copper 0-1 4. Manufacturer/Importer/Supplier/Distributor information Company Name Address Telephone E-mail Transport Emergency Emergency First Aid Contact person Oatey Co. Identification Product identifier Oatey No. ![]()
0 Comments
Read More
Leave a Reply. |